
Ether10.Genius - Double-Port 10Gb/s tester
World' smallest 10GbE tester equipped with two SFP+ ports

Ether10.Genius the smallest double-port 10GbE tester also includes GbE, 1000/100/10BASE-T, SyncE, PTP, E1, C37.94 and Datacom. All the features field engineers need to turn-up and troubleshoot new LTE networks it is capable to verify both the transmission layer and clocks that synchronize the mobile network. The C37.94 support includes BER and one-way delay ideal for Power Utility companies willing to check the protection of high voltage substations.
Detailed specs on Producer site
You may buy just a last generation dual port 10GbE tester and then you may add other interfaces just when you need it by a simple and easy upgrade by code. Then you will be able to get the new firmware supporting the desired functionalities.

6h. of continuous Operation at 10 Gbit/s
- Double port 10GbE
- 2 x SFP+
- C37.94: BER, event gen/ana
- One-way-delay with GPS
- ESMC / SSM generation analysis and capture
- Y.1564 (e-SAM) 2-way FTD, FLR SES, PEU and PEA
- Y.1731 QoS statistics
- Sym/Asym RFC2544
- FCS error insertion
- L1/L2/L3/L4 loopback
- Multistreams for IPTV, VoIP, Q-in-Q for demarcation tests
- MPLS support
- Scan MAC/IP/VLAN/QinQ
- SyncE / PTP wander
- SNMP support
- Cisco Data Cables

GbE Features
- Y.1564 (e-SAM) FTD, 2-way FDV, FDV, 2-way FTD, FLR, SES, PEU and PEA
- Y.1731 QoS statistics
- 2xSFP+, 2xRJ45 interfaces
- Symmetrical & Asymmetrical RFC2544 test
- FCS error insertion in pass-through mode
- L1/L2/L3/L4 loopback
- Multistreams for IPTV, VoIP, and Critical Data verification
- Q-in-Q for demarcation tests
- MPLS support
- Scan MAC/IP/VLAN/QinQ
- Advanced Counts: Up to 8 filters at MAC, IP, TCP/UDP, Arbitrary [mask + offset]
- Migrable to Synchronous Ethernet (SyncE)
SyncE Features
- Synchronization according G8261, G8262, G8264
- Ethernet Line frequency (MHz), offset (ppm), drift (ppm/s)
- Analysis / Generation ESMC messages and SSM count and rate
- Ext. clock input including 2048 kb/s, 2048 Hz, and Synchronous Ethernet
- SyncE MTIE / TDEV measurement
- SyncE Wander analysis/generation
- PTP / IEEE 1588v2 support decoding
- PTP support / generation as master or slave
- Master Clock operation on each port using internal/external ref.
- Y.1564 (e-SAM) FTD, 2-way FDV, FDV, 2-way FTD, FLR, SES, PEU & PEA
- Y.1731 QoS statistics
- 2xSFP + 2 x RJ45 i/faces
- Symmetrical & Asymmetrical RFC2544 test
- FCS error insertion in pass-through mode
- L1/L2/L3/L4 loopback
- Multistreams for IPTV, VoIP, and Critical Data verification
- Q-in-Q for demarcation tests
- MPLS support
- Scan MAC/IP/VLAN/QinQ
- Advanced Counts: Up to 8 filters at MAC, IP, TCP/UDP, Arbitrary
E1 Features
- Port A: Coaxial Pair Impedance: 75 Ohm BNC unbalanced and 120 Ohm RJ-45 balanced
- Port B: Symmetrical Pair Impedance 120 Ohm RJ-45 balanced
- Analogue voice frequency audio port.
- Additional balanced secondary E1 port 0 to -6dB, nominal and PMP -20dB
- Operation: Terminal, Through and Monitor
- Bit Rate: 2048 Kbit/s (+/- 3ppm)
- Codes: HDB3 / AMI
- Unframed
- PCM31: FAS / FAS+CRC4
- PCM30: FAS+CAS / FAS+CRC
- Force Single Error: Bit, Frame, CRC, and BPV (Bipolar Violation)
- G.826, G.821, and M.2100
- RTD and VF tone generation
- One-way Delay (GPS accuracy)
- Alarms and errors count, and generation
Jitter Wander Features
- ITU-T G.823 compliant (jitter)
- Overpass O.172
- Jitter level, tolerance, transfer
- Event detection
- 100% digital based generation and analyzer
- Wander Generation and Measurements (TIE, MTIE, TDEV)
- Wander results from 20 to 100 000s
Datacom Features
- Smart Serial 26p DTE / DCE ports
- V.11/X.24, V.24/V.28, V.24/V.35, V.24/V.11 (V.36/RS449), EIA530 and EIA-530A
- Codirectional according G.703
- Rate: 50, 60 bit/s, 1.2, 2.4, 4.8, 8, 9.6, 16, 19.2, 32, 48, 72, 128, 144, 192, 1544 kbit/s
- N x 56 kbit/s (N=1 to 27); N x 64 kbit/s (N=1 to 32), up to 10 Mbit/s
- DTE, DCE emulation and monitor
C37.94 Measurement
- Test Rate: N x 64 kbit/s, N = 1 to 12
- Configuration of internal, recovered clock
- Frame/Unframed BER test patterns
- ITU-T G.821 performance: ES, SES, UAS, DM
- Results with pass / fail indications Test pattern generation / analysis
- Frequency (Hz), Deviation (ppm), Max deviation
- Round Trip Delay (ms)
- One-way Delay synchronized with GPS (us)
- Optical Power Meter
- Defects: LOC, AIS, LOF, RDI, LSS, All 0, All 1
- Anomalies: FAS, TSE, Slip
Users
- LTE operators
- Power utilities
- Telecom Installers and Operators
- Network Clock manufacturers
- Triple Play service providers
- R&D, Universities, Labs
- Commission / Maintenance