
Ether.Genius - 1GbE tester
All-in-one: GbE, PTP, E1, syncE, datacom, C37.94,, one-way-delay, wander, built-in GPS receiver.

ALBEDO Ether.Genius is an multitechnology tester equipped with all the features to install and troubleshoot telecom networks based on Gigabit Ethernet (GbE), Synchronous Ethernet (SYNCE), Precision Time Protocol (PTP IEEE 1588), E1, 2Mbit/s, Jitter, Wander, Datacom, C37.94 test, nx64k, Voice Frequency and more.
Detailed specs on Producer site
You may buy just a last generation dual port GbE tester --with exactly the same specification than ALBEDO Ether.Giga-- and then you may add any technology just when you need it by a simple and easy soft upgrade to get the new firmware, to include the new functionalities.

GbE Features
- Y.1564 (e-SAM) FTD, 2-way FDV, FDV, 2-way FTD, FLR, SES, PEU and PEA
- Y.1731 QoS statistics
- 2 x SFP + 2 x RJ45 interfaces
- Symmetrical & Asymmetrical RFC2544 test
- FCS error insertion in pass-through mode
- L1/L2/L3/L4 loopback
- Multistreams for IPTV, VoIP, and Critical Data verification
- Q-in-Q for demarcation tests
- MPLS support
- Scan MAC/IP/VLAN/QinQ
- Advanced Counts: Up to 8 filters at MAC, IP, TCP/UDP, Arbitrary [mask + offset]
- Migrable to Synchronous Ethernet (SyncE)

SyncE Features
- Synchronization according G8261, G8262, G8264
- Ethernet Line frequency (MHz), offset (ppm), drift (ppm/s)
- Analysis / Generation ESMC messages and SSM count and rate
- Ext. clock input including 2048 kb/s, 2048 Hz, and Synchronous Ethernet
- SyncE MTIE / TDEV measurement
- SyncE Wander analysis/generation
- PTP / IEEE 1588v2 support decoding
- PTP support / generation as master or slave
- Master Clock operation on each port using internal/external ref.
- Y.1564 (e-SAM) FTD, 2-way FDV, FDV, 2-way FTD, FLR, SES, PEU & PEA
- Y.1731 QoS statistics
- 2xSFP + 2 x RJ45 i/faces
- Symmetrical & Asymmetrical RFC2544 test
- FCS error insertion in pass-through mode
- L1/L2/L3/L4 loopback
- Multistreams for IPTV, VoIP, and Critical Data verification
- Q-in-Q for demarcation tests
- MPLS support
- Scan MAC/IP/VLAN/QinQ
- Advanced Counts: Up to 8 filters at MAC, IP, TCP/UDP, Arbitrary
E1 Features
- Port A: Coaxial Pair Impedance: 75 Ohm BNC unbalanced and 120 Ohm RJ-45 balanced
- Port B: Symmetrical Pair Impedance 120 Ohm RJ-45 balanced
- Analogue voice frequency audio port.
- Additional balanced secondary E1 port 0 to -6dB, nominal and PMP -20dB
- Operation: Terminal, Through and Monitor
- Bit Rate: 2048 Kbit/s (+/- 3ppm)
- Codes: HDB3 / AMI
- Unframed
- PCM31: FAS / FAS+CRC4
- PCM30: FAS+CAS / FAS+CRC
- Force Single Error: Bit, Frame, CRC, and BPV (Bipolar Violation)
- G.826, G.821, and M.2100
- RTD and VF tone generation
- One-way Delay (GPS accuracy)
- Alarms and errors count, and generation
Jitter Wander Features
- ITU-T G.823 compliant (jitter)
- Overpass O.172
- Jitter level, tolerance, transfer
- Event detection
- 100% digital based generation and analyzer
- Wander Generation and Measurements (TIE, MTIE, TDEV)
- Wander results from 20 to 100 000s
Datacom Features
- Smart Serial 26p DTE / DCE ports
- V.11/X.24, V.24/V.28, V.24/V.35, V.24/V.11 (V.36/RS449), EIA530 and EIA-530A
- Codirectional according G.703
- Rate: 50, 60 bit/s, 1.2, 2.4, 4.8, 8, 9.6, 16, 19.2, 32, 48, 72, 128, 144, 192, 1544 kbit/s
- N x 56 kbit/s (N=1 to 27); N x 64 kbit/s (N=1 to 32), up to 10 Mbit/s
- DTE, DCE emulation and monitor
C37.94 Measurement
- Test Rate: N x 64 kbit/s, N = 1 to 12
- Configuration of internal, recovered clock
- Frame/Unframed BER test patterns
- ITU-T G.821 performance: ES, SES, UAS, DM
- Results with pass / fail indications Test pattern generation / analysis
- Frequency (Hz), Deviation (ppm), Max deviation
- Round Trip Delay (ms)
- One-way Delay synchronized with GPS (us)
- Optical Power Meter
- Defects: LOC, AIS, LOF, RDI, LSS, All 0, All 1
- Anomalies: FAS, TSE, Slip
Users
- Wimax, LTE operators
- Power utilities
- Telecom Installers and Operators
- Network Clock manufacturers
- Triple Play service providers
- R&D, Universities, Labs
- Commission / Maintenance